Home > Products > Power >

ALTRONIX AL600ULACM Access Power Controller w/ Power Supply Charger


Alternative Views:

MSRP: (Members Only)

Stock Status:In Stock

Product Code: AL600ULACM

  • Input
    • Input 115VAC 60Hz rated @ 3.5.
  • Power supply input options:
    • A) One (1) common power input for ACM8/ ACM8CB and lock power factory installed.
    • B) Two (2) isolated power inputs- One (1) to power the the ACM8/ACM8CB and one (1) for lock accessory power, (external power supply is required). (Current is determined by the power supply connected, not to exceed a maximum of 10A total).
    • Eight (8) Access Control System trigger inputs.
  • Input options:
    • A) Eight (8) normally open (NO) inputs.
    • B) Eight (8) open collector inputs.
    • C) Any combination of the above
  • Output
    • 12VDC or 24VDC @ 6A supply current.
    • Eight (8) independently controlled outputs.
  • Output options:
    • A) Eight (8) Fail-Safe and/or Fail-Secure power outputs.
    • B) Eight (8) form "C" 5A rated relay outputs
    • C) Any combination of the above.
    • Eight (8) auxiliary power outputs (unstitched)
  • Output ratings:
    • Fuses are rated @ 3.5A.
    • Filtred and electronically regulated outputs (built-in power supply).
    • ACM8 board main fuse is rated at 10A.
  • Supervision
    • AC fail supervision (form "C" contacts).
    • Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
    • Low battery and battery presence supervision (form "C" contact).
  • Features
    • Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the eight (8) outputs.
  • Fire Alarm disconnect input options:
    • A) Normally open (NO) or normally closed (NC) fry contact input.
    • B) Polarity reversal input from FACP signaling circuit.
    • Alarm output relay indicates that FACP input is triggered (form "C" contact rated @ 1A 28VDC).
    • Short circuit and thermal overload protection.
    • AC fail supervision (form "C" contact).
  • Visual Indicators
    • Red LEDs indicate outputs are triggered (relays energized).
    • Green LED indicates FACP disconnect is triggered.
    • AC input and DC output LED indicators.
  • Battery Backup
    • Built-in charger for sealed lead acid or gel type batteries.
    • Automatic switch over to stand-by battery when AC fails.
      • Zero voltage drop when unit switches over to battery backup (AC failure condition).
      • Battery fail and battery presence supervision (form "C" contact).
    • Temperature
      • Operating: 0° C to 49° C (32° F to 120° F).
      • Storage: -20° C to 70° C (-4° F to 158° F ).
      • Relative Humidity 85% ± 5%.
        • BTU/HR. (approx.):
          • 12VDC: 37 BTU/Hr.
          • 24VDC: 74 BTU/Hr.

    Share your knowledge of this product. Be the first to write a review »